GPD 30040C

The condenser is designed to remove heat from A/C refrigerant collected inside the system. On most vehicles, condensers cannot be cleaned or flushed. gpd highly recommends replacing the condenser every time a new compressor is installed. gpd 30040C is the preferred replacement for your 16-19 BMW X1 or similar model

• Meets/ exceeds OE fit, form, and function
• 100% leak tested
• Direct fit replacement
• Application Specific

Aluminum doesn't rust but can corrode, especially when exposed to road salt and other elements on the front of a vehicle. Corrosion is an insulator, reducing a condenser's heat exchange capacity and putting extra wear on the A/C Compressor and other components. Corrosion may cause a puncture, venting environmentally harmful refrigerant into the air and requiring an expensive repair and recharge. A condenser with Additional Corrosion Protection extends the lifespan of the whole A/C system!

Installation Tips

• Old Refrigerant must be removed from the system in accordance with local, state, and federal laws.
• Replace the A/C System O-Rings / Seals connected to the A/C Condenser to prevent a Refrigerant leak.
• If the new A/C Condenser does not have an integrated drier, replace the A/C Receiver Drier / Accumulator as well. After opening your A/C System, this part becomes saturated with moisture and needs to be replaced.
• After installing the new A/C Condenser, evacuate the system for at least 45 minutes to remove any moisture. Make sure it holds vacuum for at least 5 minutes. If it does not, you may have a leak in the system. Find the leaking component and repair or replace it.
• Recharge the system with the correct amount and type of Refrigerant as specified in your Owner's Manual.

Videos

Warranty Information:12 Months

CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.