Features:
- High-quality heat and oil-resistant elastomeric hose material withstands high pressure pulsation thanks to fiber braid reinforcement
- Manufactured to OE hose dimensions for easy installation and a tight leak-proof fit
- Replacement of old cracked and leaking power steering return hoses helps prevent low-fluid cavitation and "run dry" damage to power steering pump
Installation Tips
- Replace all power steering hoses at the same time, to prevent system contamination
- Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
- Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
- Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
Attention California Customers - WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Alternate/OEM Part Number(s)
{Alternate Inventory Numbers: URO013859}
Warranty Information
Warranty Information:24 Month / Unlimited Mile Limited
CAPA CERTIFIED or NSF CERTIFIED
CAPA Certified or NSF Certified parts bear the seal of independent, third party organizations guaranteeing fitment and quality equal to original equipment. These parts may be required if your insurance company is paying for the repair.
| Specifications |
| Color |
Natural and Black |
| End 2 Type |
Male |
| Finish |
Zinc Coated |
| Length (MM) |
673 MM |
| Material |
Zinc Single Wall Steel |
| Outside Diameter |
12 , 19.5 MM |
| Hardware Included |
No |
| Gasket or Seal Included |
No |
| Length |
26.5 IN |
| Mounting Bracket Included |
No |
| Inside Diameter |
11 mm |
| O-rings included |
No |
| End 1 Type |
Banjo |
| Flexible |
Yes |
| Protective Shield Included |
No |
| Tube Included |
No |
| Lubricant Included |
No |
| Bracket Bushings Included |
No |
| Copper Washers Included |
No |
| Crimped Sleeve Material |
Anti Corrosion Steel |
| Heat Sleeves Included |
No |
| Hose Position |
Gearbox/rack to cooler |
| Rubber Hose Standard |
Exceeds SAE J188 specifications |
| Rubber Mounts Included |
No |
| Switch Port Included |
No |
| Clamp Included |
Yes |
| End 1 Fitting Size (IN) |
0.64 IN |
| End 2 Fitting Size (IN) |
0.377 IN |
| Fully Assembled Pressure & Return Set |
No |
| Hose Positioning Clips Included |
No |
